This includes the ability to signal member status changes (for example, failed or recovered) to the far-end LAG partner so that traffic is only passed on good links. LAG partner systems use the standard (802.3) Link Aggregation Control Protocol (LACP) to manage the state of LAG port members. Refer to the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) TL1 Command Guide for MSPP as required when provisioning the VLNC5x circuit pack. Refer to the Alcatel-Lucent 1850 Transport Service Switch (TSS-5) Command Line Interface Guide and/or Alcatel-Lucent 1850 Transport Service Switch (TSS-5) CLI User Provisioning Guide as required when provisioning the VLNC42/42B circuit pack. Refer to the User Provisioning Guide, 8DG25698BAAATQZZA as required when provisioning the. This procedure provide examples for configuring the VLNC5x and VLNC42/42B circuit packs at Alcatel-Lucent 1850 TSS-5 nodes. Procedure 11-8: Provision VLAN segregation/aggregation in Ethernet over SONET/SDH (EoS) network. To provision VLAN segregation/aggregation that bridges VLAN traffic to various destinations over an Ethernet over SONET/SDH (EoS) network, refer to Mapping non-LAG traffic to the other six VCGs on the VLNC5x circuit pack is supported.

Untagged traffic is always mapped to a LAG VCG.

Up to 120 VLAN entries are supported to classify traffic. The traffic on VLNC42/42B ports d2-3 and d2-4 (P3 and P4) can be marked with VLAN tags to identify its original port and multiplexed over the backplane GbE port (d2-4) to VCGs on the VLNC5x circuit pack. The VLNC5x circuit pack GbE port (d1-1) is connected via the backplane to the VLNC42/42B circuit pack GbE port (d2-4).

Software lag switch serial